There are many ways to install LCD splicing screen, we can choose according to the specific situation of the scene environment. At the same time, due to the difference between LCD and LED, there are some skills and methods in the installation of LCD splicing screen, so that the whole installation process will be smoother and the screen will not be damaged. The following is a detailed introduction to some installation skills and methods of LCD splicing screen manufacturers.
LCD splicing screen installation
First: determine the installation method
The weight of a single LCD splicing screen is about 25kg, and the entire large screen will be very heavy after splicing. At this time, if you want to install it on the wall, you must ensure that the wall is a solid concrete wall or a brick wall. If the number exceeds nine, we must consider the convenience of after-sales work in the later stage, and it is best to add a front maintenance bracket. In addition, the LCD splicing screen can also be installed in various ways, such as cabinets, brackets, etc.
LCD splicing screen installation method
Second: first install the screen and then renovate or first renovate and then install the screen
In order to achieve better visual effects, many of our users usually wrap around the LCD splicing screen, some use aluminum-plastic panels, some use sound-absorbing panels or anti-collision corners, etc.
At this time, the fundamental issue of whether to install the screen or decorate first is considered. In our opinion, either of the two can be installed first, but there are a few things to keep in mind. If you want to install the LCD splicing screen first, you need to reserve more than 2cm of space around the screen to prevent the decoration materials from colliding or squeezing on the screen in the later decoration, and there is a buffer space to reduce the screen damage rate. If the screen is installed after decoration, the size of the entire area should be calculated in advance according to the number of LCD splicing screens and flat seams, and at the same time, a part of the space should be reserved to facilitate the construction of technicians.
LCD splicing installation skills
Third: first install the lower layer, then install the upper layer
In actual installation, there are usually multi-row LCD splicing screens. According to our years of on-site installation experience, it is recommended to install the bottom layer first, and then install it upwards in turn. The purpose of this operation is to facilitate the installation to the last layer and reduce the difficulty of installation.
LCD splicing installation steps
Fourth: Adjust the proper position of the seam
After fixing the screen on the bracket, you need to adjust the seam of the LCD splicing screen. The rule here is that the seams should not be too large and at the same time not too tight. If the adjustment is too large, the entire seam will greatly affect the viewing effect. If the adjustment is too tight, it is easy to cause the screens to squeeze each other. Under normal circumstances, after the adjustment is completed, it is better to pass a piece of A4 paper smoothly.
LCD splicing screen installation effect
Fifth: Lines should be separated
Network cables, power cables, and HDMI signal cables are the most commonly used auxiliary materials. At this time, in order to avoid the generation of static electricity, it is best to separate the wires to reduce mutual influence.
In the installation, because there are usually more LCD splicing screens involved, it is necessary to control them not to squeeze each other and the seam can be too large. At this time, the technical requirements are very high, and we should not think that it is enough to superimpose the LCD splicing screen into one piece. Pay attention to the installation skills and methods of the above-mentioned LCD splicing screen, and the installation can be more smooth.
